May Manufacturing Island spas Manuel du propriétaire télécharger pdf (Page 27)

THE SETTINGS SCREEN

Temp Range

The rst setting available to change is Temp Range. This system incorpo-

rates two temperature range settings. The specic range that is selected

(High or Low) will be displayed in the upper right hand corner of the main

screen.

High range can be set between 80°F and 104°F.

Low range can be set between 50°F and 99°F.

Jets 4/Navigate Left Button:

Press the left button to high light the Back Icon.

Jets 3/Down navigation:

Press the down button to go to Heat Mode.

Heat Mode

Heat Mode indicates if the spa is Ready mode or Rest Mode. The heat

mode will be displayed in the bottom right screen of the main screen dis-

play.

Ready Mode:

In ready mode the heater will maintain the set temperature. If your Plati-

num Elite spa is not programmed for 24 hours Filter it will turn on the circu-

lation pump every half an hour to test the water temperature. If the water

temperature is one degree below the set point the circulation pump will

continue to run to bring the water temperature to the set point temperature.

If the water temperature is at the set point temperature the circulation

pump will turn off after 5 minutes.If your ltration cycle is set for 24 hours,

the circulation pump will continue to run.

Rest Mode:

Will only allow the spa to heat during a ltration cycle.

If the spa is not in a ltration cycle, you can press the pump 1 pump to

activate the heater. The spa will go into Ready mode for 1 hour and then

go back to rest mode.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

Pas de commentaire

May Manufacturing Island spas Manuel du propriétaire Page 27